top of page
Search

Your Defender Filter Needs More Than a Daily Bump

14 hours ago
3 min read

Neptune Benson Defender regenerative media filters have earned a reputation as some of the lowest-effort filters in the pump room. There's no backwash to schedule, and the filter handles its own daily cleaning cycle. But low maintenance isn't the same as no maintenance. A Defender can run for 20 years or more, and the facilities that get that kind of life out of theirs tend to follow a simple, predictable care schedule. Here's what that schedule looks like.


A quick refresher: how the Defender keeps itself clean


Instead of backwashing, a Defender "bumps." Once a day the tube sheet moves up and down inside the tank, knocking the perlite media and trapped dirt off the flexible tube elements so the media can recoat the tubes with a fresh surface. The whole cycle takes about 10 minutes. After roughly four weeks of daily bumps (longer or shorter depending on bather load), the perlite is loaded with dirt and gets swapped for a fresh charge.


Neptune Benson Defender regenerative media filter

A Neptune Benson Defender regenerative media filter.


Bumping handles particles well. What it can't fully remove are the oils, lotions and body fats that slowly coat the tube elements over time. That's where scheduled maintenance comes in.


Defender tube sheet covered in matted lint, hair and fibers

Inside a Defender that's overdue for cleaning: lint, hair and fibers matted onto the tube sheet.


Tube element cleaning: at least once a year


Neptune Benson recommends a thorough cleaning of the Defender every year. Signs your tube elements may be due sooner:


  • Pressure climbing faster than normal after a fresh perlite charge

  • Media changes needed more often than usual for your bather load

  • Water clarity slipping even though the filter is bumping on schedule


For seasonal outdoor pools, the end of the season is the ideal time. Degreasing the filter before it sits for the winter keeps buildup from hardening on the tubes and makes spring start-up much smoother. Year-round indoor pools can schedule cleaning during a planned slow period or shutdown.


CEM technician working on a Defender tube sheet during maintenance

A CEM tech working on a Defender tube sheet during maintenance.


Five-Year Maintenance


Around the five-year mark, the bump mechanism needs a closer look. The bushings and O-rings in the bump assembly wear a little with every daily cycle, so they are inspected and replaced as needed. Staying ahead of this keeps the bump stroke working properly and helps you avoid an unexpected shutdown in the middle of your busy season.


Ten-Year Maintenance


At ten years, the tube elements get a full inspection along with the bump assembly components, and parts are replaced as needed. Some tubes may be ready for replacement by then, although well-maintained tubes can last much longer. Planning for this visit ahead of time also lets you budget for parts instead of being surprised by them.


Upgrading an older controller


If your Defender still has an older controller, it can be upgraded to the current RMF12 controller. Newer controls make it easier to manage bump and precoat cycles, keep track of maintenance, and see how the filter is performing.


A simple care calendar


  • Daily: let the automatic bump cycle run, and log your filter pressures

  • Every few weeks: replace the perlite charge, based on pressure and bather load

  • Every year: clean and degrease the tube elements

  • Year 5: inspect the bump assembly and replace bushings and O-rings as needed

  • Year 10: inspect the tube elements and bump components, and replace parts as needed


Always follow the owner's manual for your specific model. Neptune Benson's Defender filter FAQ and their pool equipment lifecycle guide are good places to learn more.


We're here to help


CEM is Neptune Benson's factory-trained and certified representative in Colorado, and our technicians service Defender filters across the region. If you're not sure when your filter last had a tube cleaning or a Five-Year service, give our team a call at 303-762-9470 or email services@cemsales.com. For general questions, reach us at info@cemsales.com.

 
 
 

Comments


bottom of page